Programming your Chrysler Town & Country’s HomeLink system to operate your garage door is a convenient feature that simplifies your daily routine. This guide will walk you through the steps to program your garage door opener to your vehicle’s built-in HomeLink system, ensuring a seamless integration. Whether you have a standard garage door opener or a rolling code system, the process is straightforward.
Erasing Existing HomeLink Programming (If Necessary)
If you are programming a new garage door opener or want to clear previous settings, start by erasing the existing HomeLink programming. To do this, press and hold the two outside buttons on your HomeLink system for approximately 20 seconds. The red indicator light will flash, indicating that the memory has been cleared.
Programming Your Garage Door Opener (Standard)
Ensure your Chrysler Town & Country is parked outside your garage. Follow these steps to program your HomeLink system with a standard garage door opener:
Step-by-Step Instructions
- Turn your vehicle’s ignition to the ON/RUN position.
- Take your handheld garage door remote transmitter. Position the battery side of the remote away from the HomeLink button you wish to program. Place the transmitter 1 to 3 inches (3 to 8 cm) away from the chosen HomeLink button, keeping the indicator light visible.
- Simultaneously press and hold both the selected HomeLink button in your car and the button on your handheld transmitter.
- Keep holding both buttons until the HomeLink indicator light changes from a slow blink to a rapid blink. This may take up to 30 seconds, and in rare cases, longer. You might see your garage door open or close during this training process.
- Once the indicator light is blinking rapidly, release both buttons. The HomeLink button is now programmed.
- Press and hold the newly programmed HomeLink button and observe the indicator light. If the light stays on constantly, programming is complete. Pressing the HomeLink button should now activate your garage door.
Programming Rolling Code Systems
If, after completing the standard programming steps, the indicator light blinks rapidly for two seconds and then turns to a constant light, your garage door opener uses a rolling code system. Additional steps are needed to finalize the programming:
Step-by-Step Instructions (Rolling Code)
- Locate the “Learn” or “Training” button on your garage door opener motor unit inside your garage. This button is typically near the antenna wire connection. The button’s name and color may vary depending on the manufacturer, but it’s distinct from the button you normally use to open and close the door.
- Firmly press and release the LEARN or TRAINING button. Note that you usually have a 30-second window to complete the next step after pressing this button.
- Return to your Chrysler Town & Country and press the programmed HomeLink button twice, holding it for two seconds each time.
- If your garage door activates, programming is complete. If not, press the HomeLink button a third time for two seconds to finalize the training.
Need Help?
If you encounter any difficulties or need further assistance, you can contact HomeLink customer support toll-free at 1–800–355–3515. Alternatively, you can visit the official HomeLink website at www.HomeLink.com for more information and support resources.
By following these instructions, you should be able to successfully program your Chrysler Town & Country’s HomeLink system to your garage door opener, adding convenience and ease to your daily comings and goings.
