Lost your Pontiac G6 car remote or need to program a new one? Instead of heading straight to a dealership and paying a hefty fee, you can easily program your key fob yourself. This guide provides simple, step-by-step instructions to program your Pontiac G6 remote, saving you time and money.
Step-by-Step Programming Instructions
Follow these instructions carefully to program your Pontiac G6 remote. It’s a straightforward process that can be done in a few minutes without any special tools.
Step 1: Prepare Your Vehicle
Begin by sitting in the driver’s seat of your Pontiac G6. Ensure the ignition key is removed from the ignition lock cylinder and all vehicle doors are completely closed. While the original instructions specify the driver’s seat, some users find it easier to perform the next steps from the front passenger seat, so choose whichever is more comfortable for you.
Step 2: Fuse Removal
Locate the fuse panel in your Pontiac G6. Find and remove the “MALL PGM” fuse. Consult your vehicle’s owner’s manual if you are unsure of the fuse panel location or the MALL PGM fuse.
Step 3: Ignition and Door Cycle
Now, insert the ignition key into the ignition lock cylinder and turn it to the “ACC” (Accessory) position. Immediately turn the ignition lock cylinder back to the “OFF” position, and then quickly back to “ACC” again, all within one second. After this, open and then close any vehicle door.
Step 4: Programming Mode Confirmation
Listen carefully for a chime. This chime indicates that the remote control door lock receiver has successfully entered the programming/diagnostic mode. If you do not hear a chime, you will need to restart the process from Step 1 and ensure each step is followed precisely.
Step 5: Remote Synchronization
Take the remote transmitter you wish to program. Press and hold down both the “LOCK” and “UNLOCK” buttons simultaneously for approximately 14 seconds. After about 7 seconds, you may hear a chime confirming successful synchronization with the receiver. Continue holding for the full 14 seconds, after which you should hear another chime confirming successful programming of the remote.
If you have additional remotes to program, repeat Step 5 for each transmitter.
Step 6: Final Steps
Once you have programmed all desired remotes, remove the ignition key from the ignition lock cylinder. Return to the fuse panel and reinstall the “MALL PGM” fuse that you removed in Step 2.
Important Notes and Tips
- Erase Previous Programming: Be aware that once your Pontiac G6 enters programming mode, it erases all previously programmed remotes. Therefore, you must program all of your remotes (both old and new) during this session.
- Program One Vehicle at a Time: If you are programming remotes for multiple vehicles, ensure you program them one at a time. Programming multiple vehicles simultaneously can lead to a remote being incorrectly programmed to more than one vehicle.
- Chime Confirmation: The chime is crucial for confirming each stage of the programming process. Pay close attention to these chimes to ensure you are proceeding correctly.
- Fuse Location: Always refer to your Pontiac G6 owner’s manual for the exact location of the fuse panel and the “MALL PGM” fuse. Incorrect fuse removal could lead to issues.
By following these steps, you can easily program your Pontiac G6 car remote and regain full keyless entry functionality without the expense of a locksmith or dealership service. Always double-check each step and ensure you hear the confirmation chimes for a successful programming experience.
