Programming your ProStart remote car starter can seem daunting, but it’s actually a straightforward process you can complete yourself. This guide provides clear, step-by-step instructions to get your ProStart remote programmed and working smoothly with your vehicle. Whether you’re replacing a lost remote or adding an extra one, follow these simple directions to quickly program your ProStart key fob remote.
Step-by-Step Guide to Program Your ProStart Remote
To begin programming your ProStart remote, ensure you have your vehicle’s key and locate the Valet switch, typically found under the hood.
-
Disengage Valet Mode: Start by opening your car’s hood using the hood release lever inside your vehicle. Then, locate the Valet switch and turn it to the “Off” position. This step is crucial for initiating the programming sequence.
-
Ignition ON (Engine OFF): Insert your car key into the ignition and turn it to the “On” position. It’s important to only turn the ignition to “On” and not start the engine. Keep the engine off throughout the programming process.
-
Engage Valet Mode and Observe Parking Lights: Now, turn the Valet switch back to the “On” position. Immediately watch for your parking lights; they should illuminate and remain on for approximately five seconds. This indicates that your vehicle is in programming mode.
-
Remote Activation: Within those five seconds while the parking lights are illuminated, press and release the “CH1” button, often labeled as “Button 1,” on your ProStart remote. Upon pressing the button, you should observe your parking lights flashing. They will flash a total of seven times – five quick flashes followed by two slower flashes. This confirms successful programming of your remote.
-
завершение программирования: Turn your vehicle’s ignition off by turning the car key back to the “Off” position and remove the key from the ignition. Finally, close your car’s hood. Your ProStart remote should now be programmed and ready to use. Test the remote to ensure it’s working correctly.
If you encounter any difficulties programming your remote, or prefer professional assistance, you can search for a certified key fob installer in your local area. They can provide expert programming services and ensure your ProStart system functions perfectly.
