Have you recently purchased a new key fob for your Honda CRV, or perhaps the battery in your existing remote has died? Don’t worry, programming your key fob for your Honda CRV is a straightforward process you can easily accomplish at home. Forget about the inconvenience and expense of dealership programming – you can get your remote working again in just a few simple steps. This guide will walk you through exactly how to program your Honda CRV key fob quickly and efficiently.
Step-by-Step Guide to Programming Your Honda CRV Key Fob
Follow these nine simple steps to program your key fob for your Honda CRV. Remember to perform these steps relatively quickly, as timing is important for successful programming.
Step 1: Gather All Your Remotes
Before you begin, make sure you have all the key fobs you intend to use with your Honda CRV. Even if you are only programming a new remote, all remotes you want to use must be programmed in the same session. The system will effectively “forget” any previously programmed remotes if they are not included in the current programming sequence.
Step 2: Get Inside Your Honda CRV
Enter your Honda CRV and ensure all doors are completely closed and unlocked. This is crucial for the programming sequence to initiate correctly.
Step 3: Turn the Ignition to the “ON” Position
Insert your key into the ignition and turn it to the “ON” position. This is the position right before you would start the engine. You should see the accessory lights illuminate and the dashboard lights come on.
Step 4: Press the “LOCK” Button Quickly
Within five seconds of turning the key to the “ON” position, press the “LOCK” button on your key fob transmitter for approximately one second.
Step 5: Turn the Ignition to the “OFF” Position
Immediately after pressing the “LOCK” button, turn the ignition key back to the “OFF” position. Do not remove the key from the ignition.
Step 6: Repeat the ON/OFF Cycle
Repeat Steps 4 and 5 two more times. This means you will cycle the ignition from “ON” to “OFF” a total of three times, pressing the “LOCK” button for one second each time while turning the key to “ON”. Each step needs to be completed within five seconds of the preceding step to maintain the programming sequence.
Step 7: Enter Programming Mode
Turn the key back to the “ON” position for the fourth time. Within five seconds of this fourth “ON” turn, press the “LOCK” button on your remote once more. If you have successfully entered programming mode, you will hear the door locks make a distinct “clunk” sound. This sound indicates that your Honda CRV is now in Remote Programming Mode and is ready to learn the remote signals. Do not turn the key off at this point.
Step 8: Program Additional Remotes (If Necessary)
If you are programming multiple key fobs, now is the time to program the additional remotes. Within 10 seconds of entering programming mode (indicated by the door lock “clunk”), press the “LOCK” button on each additional remote you wish to program for one second each. You will hear the door locks “clunk” again after each remote is successfully programmed, confirming that it has been stored in the system’s memory. A Honda CRV can typically store up to three remotes.
Step 9: Exit Programming Mode and Test
Finally, turn the ignition key to the “OFF” position and remove the key from the ignition. Now, test each of your programmed key fobs to ensure they are working correctly by pressing the “LOCK” and “UNLOCK” buttons. You should hear the doors lock and unlock in response to each remote.
Important Reminders
Keep in mind that your key fob remote will not operate if the key is in the ignition. If you have lost a keyless entry remote for your Honda CRV, reprogramming your remaining remotes is a smart security measure to help protect your vehicle from potential theft. By following these steps, you can easily program your Honda CRV key fob and regain the convenience of keyless entry.
